The selection of the specification of ht hepa filter manufacturer should match the installation pipeline. When the flow rate of ht hepa filter manufacturer cannot meet the requirements of the pipeline, Two (or more)ht hepa filter manufacturers can be installed in parallel or subjected to side filtering treatment.

2. The ht hepa filter manufacturer should be installed as close as possible to the place where the system needs protection. The low inlet pressure affects the use, so it should also be installed near the pressure source.

3. The ht hepa filter manufacturer should be installed in series in the pipeline system. To ensure uninterrupted water supply to the system during shutdown and maintenance, it is recommended to set a bypass in the system. Ball valves for shut-off should be installed at the inlet and outlet of the ht hepa filter manufacturer and on the bypass. Where backflow is possible, a check valve should be installed at the outlet of the ht hepa filter manufacturer.

4. When selecting the model, pay attention that the water temperature flowing through the fully automatic self-cleaning ht hepa filter manufacturer does not exceed its applicable temperature.

5. The installation site is equipped with three-phase 380V industrial frequency AC power (three-phase four-wire system). The sewage pipe should not exceed 5 meters to avoid back pressure.

6. For DC systems, pay attention to filtration accuracy, pretreatment, and pressure matters. For intermittent systems, be cautious when using the timing control type.

7. Choose the installation environment reasonably and pay attention to waterproofing, rainproofing and moisture-proofing.

Note: When the backwashing system is out of operation for a long time or seasonally, before the system stops running, add an appropriate amount of corrosion inhibitor to the water and take full water wet protection measures to reduce corrosion and protect the system.

This equipment has been debugged before leaving the factory. Users can run it directly when in use. When the operating parameters of the equipment cannot meet the user's requirements, the user can adjust each parameter according to the actual working conditions and accordingly select manual control or automatic control mode for operation.

During operation, the following steps should be followed:

1. Check whether the ht hepa filter manufacturer is in a normal working state:

2. Check whether each connection of the ht hepa filter manufacturer is firm.

3. Check that the electrical control box part of the ht hepa filter manufacturer should be dry.

4. Connect the power supply. When the green power indicator light is on, it indicates that the electrical control part of ht hepa filter manufacturer is in a normal working state and the equipment can be put into trial operation.

Note: When plugging in the power supply, it is necessary to keep your hands dry. Meanwhile, during the operation of the ht hepa filter manufacturer, the electronic control part should be kept dry and no water should enter the interior of the electronic control.

ht hepa filter manufacturer https://www.ast-filter.com/HT-HEPA-Filter.html